G .240" Suitable for: 17 Hornet Generic image for reference only Learn More

Regulating seating depth and the resulting "jump" to the rifling is widely regarded as fundamental to improved accuracy. A few thousandths of an inch change between the bullet and the rifling can make the difference between average accuracy and real tack-driver performance. Learn More

For handloaders who want "hands-on" accurate control of their powder charges. FEATURES Delivers an initial large volume powder charge with the ability to nish with small precision metering. Manual high and low speeds with up to a three-to-one gear ratio. Double-sided, sealed ball bearings prevent stray powder from impeding operation. Generic image for reference only Learn More

This double-sided block holds 50 cases and helps streamline powder charging and inspection. Fits 223 Learn More

Youll receive all the advantages of Lock-N-Load technology with the added benefit of more precise measuring. That precision comes from a specially designed chrome-plated metering insert and a smaller metering chamber to promote more consistent and uniform filling. Learn More

Hornady Lock-N-Load Cartridge Gauges allow the user to check their cases and ammo to ensure a correct fit in SAAMI chambers. Learn More

Learn More

Hornady Match Grade Dies give you total control over neck tension in the resizing process. These dies feature the ability to use interchangeable, self-centering neck size bushings that eliminate the chance of over sizing your case necks and overworking the brass.* Tight tolerances at the press translate into tighter groups at the range. * Bushings sold separately. Learn More

The Hornady Match Grade Bushing is required for use with the Hornady Neck Sizing die. It is a self-centring, interchangeable bushing for extreme precision in neck sizing. Notes: Bushing fits in Hornady Match-Grade full length and neck sizing die Bushing is self-centring in die body Use of Hornady Match Grade Neck and Full Length Dies and Bushings: Hornady Match Grade dies have a separate, interchangeable neck size bushing (not included with die). The dimension of the bushing (inside diameter, listed) determines the neck size when the brass is inserted into the die. Standard dies size to SAAMI minimum specification and this is often not necessary, as a particular rifle, brass type and chamber may not need minimum dimensions. Less sizing results in less working of the brass. Using some loaded or dummy cartridges that fit the rifles chamber without excessive play, measure the diameter of the case neck. Subtract .001" from that diameter and the result should be a reasonable starting point for the correct bushing dimension. Select a size that is at that dimension or just under it. Bushings work in both the neck and full length Match Grade dies. The bushings are available in .002" increments. The 242, 244, 246 and 248 bushings are for the 223 Remington and 22-250 Remington cartridges. The 260, 262, 264 and 266 bushings are for the 6mm PPC and 243 Winchester cartridges. The 332, 334, 336 and 338 bushings are for the 308 Winchester cartridge. Made In United States of America Learn More